KOOL-DRIVE Mercruiser Alpha Gen II Drive Shower NEW Made in USA

Description

ALPHA II DRIVE OIL COOLER
Need it for an BRAVO? - CLICK HERE
Keep your Outdrive alive with the K&B Kool-Drive.
Solid Stainless Steel Construction
Unique Water Pick Up and Discharge Nozzle
Rugged Dispersion Hood
5 Minute installation requiring no special tools
Does not add drag to your boat
Kit includes Zinc Anode as shown in the picture below.
Drive cooled below oil level for Maximum Efficiency
Cooling Action increases with Speed
You do have to go faster then 25 to get a stream out of it.
An oil cooler is not required for slower speeds.
Specifically designed for Alpha OutDrive
Requires absolutely no drive modifications
BE SURE YOU DO NOT HAVE ANY OBSTRUCTION
BETWEEN THE NOZZLE AND DISPERSION PLATE.
NOTE: YOU MUST TIGHTEN NOZZLE TUBE AND ANODE PROPERLY! WE ARE NOT RESPONSIBLE LOST PARTS OR DAMAGE FROM IMPROPER INSTALLATION
PLEASE READ THIS IMPORTANT INFORMATION:
Be sure you have an Alpha Gen II drive. The Alpha Gen I and Pre-Alpha has the retaining bolt for the anode trapped where you can't remove without dropping the lower outdrive section. Our spray tube won't fit without modification to the casting. If the anode bolt can be removed easily it will be fine.
Please Note: The instructions are the same as t he Bravo. The only difference is how the dispersion plate (The part that says Kool Drive) mounts to the lower unit. The Bravo mounts with the screws from the back and the Alpha mounts with the bolts from the top.
FACTORY DIRECT FOR ONLY .00 plus shipping
K&B Manufacturing, Inc.,
16015 Adelante St.,
Irwindale, CA 91702
MECOA - Model Engine Corporation Of America
Test results show 14% to 35% cooler running oil temperatures with Kool-Drive.