Stator + Flywheel + Gasket for Yamaha FZ1 / FZS1 / YZF R1 1000 FZ8 800 2004-2015

Description

Free
shipping in USA
2 year
warranty
Same day
shipping
visit our store >
find parts for :
ATV / UTV / SXS
Motorcycles
Snowmobiles
Watercraft
Other
Menu
Store Home
ATV / UTV / SXS
Motorcycles
Snowmobiles
Watercraft
Other
Stator + Flywheel + Gasket Yamaha FZ1 / FZS1 2006-15 FZ8 800 2011-13 YZF R1 2004-2008 | 2SH-81450-00-00 2D1-81410-10-00
KEY FEATURES
Brand new aftermarket Stator + Flywheel + Gasket kit
Direct replacement to your original unit
Plug-and-play, direct fit, easy installation
All products shipped are tested
All item pictures are accurate
DESCRIPTION
Battery condition is extremely important. No stator can work correctly with a bad or weak battery.
Always fully charge your battery before performing any charging system tests or replacing parts.
If there is any doubt, have the battery load tested or replaced.
Brand new aftermarket Stator + Improved Flywheel + Gasket
Crankcase cover gasket included
Direct replacement to your original unit
Plug-and-play, direct fit, easy installation
Stator
Highest grade of lamination materials
Highest grade of copper winding, resistant to 200 degrees Celsius
Connector included
Rubber grommet included
Flywheel
Introducing our newest Heavy Duty Flywheel Rotor For Yamaha Motorcycles
Anyone who rides or repairs a Yamaha YZF R1, FZ1 or FZ8 is probably familiar with the flywheel problems common to these models. Most of these bikes will have at least one flywheel failure in their lifetime so far. Low quality epoxy was used on OEM flywheels to secure the magnets to the rotor body. Over time and many heat cycles, the epoxy fails allowing the magnets to come loose and contact the stator, potentially causing catastrophic damage.
A Heavy Duty Flywheel to the rescue!
New RMSTATOR heavy-duty flywheel rotor for Yamaha Motorcycles is a well-priced solution to problems with the OEM flywheel, and an excellent alternative to all the mechanical troubles you can encounter with a repair.
Features
Built to OEM size
Fits precisely in your ride: install it and forget it.
Improved epoxy
Uses high temperature epoxy that is stronger than OEM, eliminating the possibility of magnet detachment.
High grade steel capping
Prevents heat and friction from degrading the epoxy attaching the magnets. Though extremely unlikely, if a magnet did ever come loose, it would remain in the sleeve preventing contact with the stator.
Precise balancing
Eliminates crankshaft vibrations for longer engine longevity.
Shop with confidence
Two years warranty. All products are tested.
Don't waste time with temporary solutions, and start fixing your ride like a pro!
Why cheap repairs won't work?
Quick stronger epoxy fixes do repair flywheels in short term. It might however impair long term performance and reliability of your ride.
Remaining OEM magnets:
Original magnets remaining can still come loose at any time.
Magnet alignment:
The alignment of magnets around the flywheel is critical for proper stator operation. Even very fine misalignment will reduce stator efficiency significantly.
Magnet spacing:
Excessive epoxy or incorrect magnet spacing around the flywheel can easily affect the flywheel balance. This can cause stator contact or even crankshaft damages.
Incorrect replacement magnets:
The magnetic field strength of new magnets MUST match the originals. Stator failure can occur quickly with stronger magnets and stator output can be decreased significantly using weaker magnets.
Wrong epoxy properties:
Epoxy that is not rated to permanently handle high temperatures can quickly cause a serious failure.
Oil contamination:
Wrong epoxy for the application can also contaminate the crankcase oil, damaging the motor.
All these reasons make us strongly recommend that you replace your broken flywheel with our new heavy duty flywheel.
Vehicle models fitment
Yamaha FZ1 1000 -- 2006-2014
Yamaha FZ1-N Fazer 1000 -- 2006-2014
Yamaha FZ1-S Fazer -- 2015
Yamaha FZ8 800 -- 2011-2013
Yamaha FZ8-N Fazer 800 -- 2011-2013
Yamaha FZS1 -- 2015
Yamaha YZF R1 1000 -- 2004-2008
OEM part replacement
106628-R00
Specifications
Stator Dimensions:
Interior diameter : 18 mm
Exterior diameter : 68 mm
Thickness : 42 mm
Length of wires stator to grommet : 125 mm
Length of wires grommet to plug : 500 mm
Other specifications :
Number of wires : 3
Number of plugs : 1
Number of pins : 3
Wire to wire resistance :
Alternator : Between each White = 0.4 ohms +/-20%
Flywheel Dimensions:
Exterior Diameter: 80 mm
Interior Diameter: 69 mm
Interior Diameter Center Housing: 12 mm
Exterior Diameter Center Housing: 18 mm
Thickness (exterior): 11 mm
Thickness (interior): 6 mm
Diameter of the Shaft largest to the narrowest:
26 mm
20 mm
18 mm
15 mm
instructions
Before installing your new Stator
Check the AC output of the stator
Replace any burned or corroded connectors on stator and regulator rectifier
Check and repair any melted wiring
Use hi-temp dielectric grease on all connectors
Our stator might have a different wire color code than your original part.
All the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.
When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible but no less than 0.010".
Flywheel
Before attempting to start your Yamaha motorcycle, adjusting the air gap is necessary. Rotate the flywheel so the raised node is lined up with the pick up/pulser coil and adjust as close as possible but no less than 0.010".
Item Delivery
Our multiple North American locations, from which we ship our products, allows us to deliver 99.7% of our orders within the specified time period. If your item is not available in our main Colorado facility, we still guarantee that your order will be delivered within the specified time period.
If your item is not delivered within this time period, we will offer you a 5.00$ discount on your order. This guarantee applies to shipments delivered in the 48 continental USA states, excluding PO boxes.
customer service
AsK seller a question
duties & taxes
International Buyers:
Import duties, taxes, and charges are not included in the item price
or shipping cost. These charges are the buyer's responsibility.
More than 20 years of assisting mechanics around the world resolving the worst electrical problems made us know our stuff. When it comes to vehicle electrics, we definitively are the power in powersports.
Customer service
Part request
About us
About seller page
Add seller to favorite